Deck skirting without the lattice.
Close the open gap under a deck or porch without a saw, a drill, or a stack of lattice. Cut the Diamond Weave panels to fit with household scissors, snap them to the rim with patented no-drill studs, and unsnap the whole run whenever you need under-deck access.
Complete kits run $899 to $2,099, sized by how much you need to close. Each kit lists the feet of skirting it includes, from 60 to 150.
Cut to your deck, not a stock panel.
A deck rarely offers the clean rectangle lattice assumes. Diamond Weave cuts to any run, around stairs, posts, and a sloping yard, so the skirt follows your real deck line instead of forcing it into pre-cut sheets. You measure the open span from the deck frame down to the ground, then trim each panel to that height on site. There is no sawing, no framing, and nothing to paint.
Snaps off when you need under there.
Storage, a crawl hatch, a shut-off valve: whatever lives under your deck stays reachable. Cut a clean opening where you need one and finish it with more snaps, or unsnap a whole section and lift it away. Because the panels snap to studs instead of screwing to a frame, getting under the deck never means unbuilding the skirt.
Keep leaves, critters, and clutter out.
An open under-deck invites blowing leaves, nesting animals, and a full view of everything you store down there. The solid Diamond Weave panels close the span off cleanly, so you hide the clutter and keep the wildlife out. The same no-drill studs, 3M VHB adhesive, and Diamond Weave material carry over from our RV skirting: for how the system works, see the complete skirting guide.
What no-drill deck skirting actually gets you.
Deck skirting,
answered.
How do you skirt a deck without drilling?
You mark the spots along the deck rim, press on the patented 3M VHB snap studs, and let them set. Then you cut the Diamond Weave panels to the height from your deck frame down to the ground and snap them on. There are no screws into your framing and no lattice to build, so nothing you attach leaves a permanent hole in the deck.
Will deck skirting keep animals out from under the deck?
Yes. The solid Diamond Weave panels close the open span so leaves, debris, and nesting animals stay out. Cut them tight to the ground and finish the bottom edge to close the gap animals look for.
Can I still get under the deck after it is installed?
Yes. Cut a clean access opening wherever you need one and edge it with snaps, or simply unsnap a whole section and lift it off. The studs stay on the deck frame, so you close it back up in seconds when you are done.
How is this different from lattice?
Lattice is cut, framed, and screwed into place, then usually painted, and it comes off in one-time pieces. EZ Snap skirting cuts to any shape with scissors, snaps on with no drilling, and unsnaps whenever you want under-deck access. It follows an uneven yard or a curved deck line that rigid lattice sheets fight.
What size kit do I need for my deck?
Measure the open perimeter you want to close, then match it to a kit by the feet of skirting it includes. Kits ship with 60 to 150 feet of Diamond Weave, so most decks and porches need only one. If your run falls between sizes, size up and trim the extra.
How much does deck skirting cost?
Complete EZ Snap kits run from $899 to $2,099, priced by how much material your run needs. A short porch or a small deck sits toward the lower end, since it takes less skirting than a long or tall wrap. Everything is covered by a Limited Lifetime materials warranty.
Skirt your deck at your own pace.
Measure the open span, cut the panels to fit, and snap them on with no drilling. Close off the space under your deck and keep it easy to open back up.