EZ Snap RV skirting.
The patented no-drill snap system that started it all. Solid Diamond Weave vinyl, cut to fit with household scissors and held on by 3M VHB snaps, with no holes in your rig. Trusted by more than 38,000 customers since 2006 and backed by a Limited Lifetime materials warranty. Build your kit direct from the maker, no dealer and no markup.
Complete kits run $899 to $2,099, custom-built to your rig. The kit builder prices yours as you configure.
Twenty years of no-drill skirting.
No-drill by design.
The whole EZ Snap system runs on one idea: a patented, no-drill snap fastener. Instead of screwing a track into your rig, you press adhesive-backed snap studs onto the surface and the panel snaps on. Each stud takes about 60 seconds to place and the 3M VHB bond reaches full strength in roughly 72 hours. It is the same fastener on a flat sidewall or the curved nose of a fifth wheel, which is what lets one system fit any rig with no holes.
Cut to your rig. Snaps off for travel.
Nothing is pre-sized. You measure your rig, enter the dimensions in the kit builder, and it prices a kit with enough Diamond Weave for your perimeter. Trim the panels to your exact height with household scissors, cut clean openings for your steps and bays, and finish them with snaps. When you travel, unsnap the whole skirt and roll it up, and the studs stay on the rig so it snaps right back on next season.
EZ Snap RV skirting,
answered.
What makes EZ Snap different?
EZ Snap is the patented no-drill snap system, made and shipped direct since 2006 to more than 38,000 customers. There is no drilling and no dealer markup: you press on the adhesive snap studs, cut solid Diamond Weave vinyl to fit with household scissors, and snap it on. Every kit is backed by a Limited Lifetime materials warranty.
Do I need to drill into my RV?
No. The snap studs use 3M VHB adhesive that presses on by hand and reaches full strength in about 72 hours. There are no screws and no holes, and nothing that marks your rig. When you travel, the panels unsnap and the studs stay put.
Will it fit my rig?
Yes. Nothing is pre-sized. You enter your dimensions in the kit builder and it prices a kit with enough material, then you cut the panels to fit around slide-outs, steps, and bays. Not sure of your size? Order a free sample or talk to a Pro before you buy.
How much does a kit cost?
Complete EZ Snap kits run from $899 to $2,099, priced by how much material your rig needs. The kit builder prices yours as you enter your dimensions. Everything is covered by a Limited Lifetime materials warranty and ships free over $225.
How much can it save on heating?
Owners report up to 40% less heating and propane use once the full perimeter is sealed. Skirting traps a still cushion of air under the rig so wind cannot strip the heat away, which keeps the space warmer with the heat you are already using.
Can I take it off and reuse it?
Yes. The panels unsnap from the studs so you can pull the whole skirt, roll it up, and store it, then snap it back on next season. The studs stay on the rig between stops, so re-hanging takes nothing but the panels you already own.
Build your EZ Snap kit.
Enter your rig's dimensions and the kit builder prices yours. Cut it to fit, snap it on with no drilling, and seal the gap for good.