How can we help you?

< Back to Previous Page
You are here:

Installing Fasteners: Clean & Prep Surface, Mount Studs & Pins


Most customers prefer using the “No-Drill” EZ Snap® 3M™ Adhesive Fasteners for their EZ Snap Shades.

Deciding which EZ Snap® Fasteners are best for you depends on the type of frames you have:


  • Stainless Steel Screw Snaps: Best for wood frames, stucco or siding mounting. Install in any temperature. No surface prep required. Be careful not to over tighten screws.

  • 3M™/Stainless Screw COMBO Snaps: 3M™ adhesive seals around screw hole. Install in any temperature. Surface prep recommended for better adhesive bond. Be careful not to over tighten screws.

  • 3M™ Adhesive Snaps: Installation temperature MUST be at least 15°c /60°F for 72 hours before attaching shades. Surface preparation required. 3M Primer Recommended.


Mounting Surface for 3M Adhesive

Smooth, Flat and 1″ Wide

No Textured Surfaces

No Curved Surfaces

Too Narrow

REQUIRED Surface Cleaning & Preparation for 3M Adhesive Studs


1. Thoroughly clean the area where the studs will be mounted with 70% isopropyl alcohol to remove any film, dirt or oxidization. Bottles of isopropyl alcohol are available in 70%, 90%, and 99% concentrations. 70% works well without dilution. 90% or 99% should be diluted with 40% or 50% water, respectively. Water content slows evaporation, increases surface contact time, and is more effective at removing contaminants and debris (than using straight alcohol).

2. 3M recommends using 3M Primer as the final surface prep before mounting studs. Follow this link for 3M Primer instructions…


3. Remove adhesive backing paper then press into place with a minimum of 15 pounds pressure (in the centre and around the edges) on each Fastener.


4. After 3M studs have been installed, wait a minimum of 60 minutes before you install the shading mesh or 24 hours, ideally.

EZ Snap Pins & Studs


5. After Studs have been mounted, snap Pins onto Studs.


Fastener Spacing


For all Fastener types, we recommend MAXIMUM 10 inch spacing on most applications.

For Shades 25 square feet or larger or in high wind areas, MAXIMUM 5 inch spacing.

Install 2 Fasteners on each corner, 1.5 inches back from the corner.

Was this article helpful?
How can we improve this article?
Please submit the reason for your vote so that we can improve the article.
Need help?
Table of Contents