Window Shades
Skylight Shades
RV Skirting
RV Shades
Boat Shades
Below are the most commonly recommended items to use along with your EZ Snap® RV Skirting kit. Although EZ Snap® does not carry these extra items, they can be found on Amazon.com using the links below.

#1 Portable Heaters – (Best RV Skirting Add-On Option)

We recommend the heaters shown in the images below. Click on the images below to purchase or for more info…
Using a heater like these will ensure you will not have any issues with frozen pipes under your RV. To purchase these heaters from Amazon, just click on the image.

  • We suggest that you place one at the rear of the RV, facing to the front.
  • If you have a long RV, we recommend two heaters. One at either end, facing each other.
  • Set the thermostat to a setting that will make the heater come on if the temperature get close to zero degrees.
  • IMPORTANT: – Make sure that there are no flammable items or gases near the heater.
  • Placing the heater on a metal cookie sheet is a good idea to keep water and moisture away.

Click on the images below to purchase or for more info:

#2 Remote Temperature Monitors.

Second most popular add-on for winterizing your RV. 
This item lets you know that your skirting and heaters are working properly.

  • Ensure that the temperature under your rig is staying above the freezing point.
  • Fine-tune the settings on the heaters so they are not set too high and wasting electricity.
  • Shows the minimum and Maximum temperatures recorded.
  • Displays temperature and humidity with jumbo 1.25 inch LCD characters which can be easily read from across the room.
  • Add additional sensors as needed.

#3 Portable RV Steps – (Eliminated fitting skirting around stairs)

We recommend using one of the Portable RV Stairs shown in the images below.
Click on the images below to purchase or for more info…

Using a set of portable RV stairs makes your RV Skirting install even quicker and easier.
To purchase these heaters from Amazon, just click on the image.

  • When you use a portable RV step system, you do not have to fit your skirting around your existing RV steps.
  • We recommend using a portable stair that has a handrail for safety, as steps can become slippery with snow and ice.

Click on the images below to purchase or for more info:

#4 Exhaust Pipe Heat Shields – (Prevents melting Skirting)

Exhaust pipe heat shields are shown in the images below.
Click on the images below to purchase or for more info…
If you are planning to run your RV exhaust or generator exhaust through to the outside of the RV Skirting, you will want to shield the RV Skirting material from the extremely high heat of the exhaust pipe.
To purchase these shields from Amazon, just click on the image.

  • Even though EZ Snap skirting can take at lot of heat, you don;t want to risk it melting on your exhaust pipes.
  • These shields will greatly reduce the amount of heat that the pipe can transfer to the skirting.

Click on the images below to purchase or for more info:

#5 Pipe Heat Tape

Pipe heat tapes are shown in the images below.
Click on the images below to purchase or for more info…
For an extra layer of protection against freezing pipes under your RV, you can add a heat tape product like the ones shown below.

  • Energy efficient method of supplying heat to critical areas behind you EZ Snap RV Skirting.
  • Easy and quick to install.

Click on the images below to purchase or for more info:

Place approximately 12 inches apart on the lens of the skylight.

AirFlo™ Spacers are recommended for all Dome Skylights or Skylights with Plastic Lens.

To use: Place the spacers approximately 12 inches apart or how every many
would be required to keep the mesh from laying on the skylight lens.

Why do we suggest the AirFlo Spacers: Many dome skylights are quality, "Made in America" skylights, but unfortunately there are
a lot of skylights on the market now that are made off-shore. In very hot weather, these poorly made skylight lens can develop crazing or imperfections in the
plastic of the skylight lens. This is caused by an excessive heat build-up in the sub-standard plastic lens.
The AirFlo™ spacers lift the shading mesh off of the lens of the skylight, allowing the excess heat to dissipate.

NOTE: Using AirFlo Spacers will slightly increase the size of the dimensions of the shading mesh you will need.

If you are confident that you have a quality built dome skylight, then these spacers
are probably not necessary for your project, but if you are unsure, better to be safe than sorry.

Outside View Black EZ Snap Shade Screens

OUTSIDE VIEW - BLACK EZ Snap Shade Screens.

INSIDE VIEW - BLACK EZ Snap Shade Screens

Outside View White EZ Snap Shade Screens

OUTSIDE VIEW - WHITE EZ Snap Shade Screens

Inside View White EZ Snap Shade Screens

INSIDE VIEW - WHITE EZ Snap Shade Screens

The Primer Pen is used for applications where it is necessary to increase the surface adhesion of the EZ Snap stud.

Contains a 3M Clear, Colorless primer. Enough to prime the surface area for approximately 50 studs.

To use: Shake the pen well before using.
A gentle squeeze 1″ in from the felt tip, ruptures the inner membrane, allowing the contents to be easily dispensed.
Apply a thin, uniform coating to the bonding surface using the minimum amount that will fully coat the surface.
Dries clear. Allow to dry thoroughly before applying the studs. This takes approximately 5 minutes at room temperature.
Extremely porous surfaces may need a second application for uniform coverage and good adhesion.

TIP: Make a template, cut-out to the same size as the stud.
This prevents wasting primer by only priming the area that the stud will bond to.
**As with all primer type products, test on small area first to ensure it is compatible with surface.