The Primer Pen is used for applications where it is necessary to increase the surface adhesion of the EZ Snap stud.

Contains a 3M Clear, Colorless primer. Enough to prime the surface area for approximately 50 studs.

To use: Shake the pen well before using.
A gentle squeeze 1″ in from the felt tip, ruptures the inner membrane, allowing the contents to be easily dispensed.
Apply a thin, uniform coating to the bonding surface using the minimum amount that will fully coat the surface.
Dries clear. Allow to dry thoroughly before applying the studs. This takes approximately 5 minutes at room temperature.
Extremely porous surfaces may need a second application for uniform coverage and good adhesion.

TIP: Make a template, cut-out to the same size as the stud.
This prevents wasting primer by only priming the area that the stud will bond to.
**As with all primer type products, test on small area first to ensure it is compatible with surface.